Duerkopp Adler HP Series Additional guide Manual de usuario descargar pdf (Pagina 77)

EFKA AB220A/320A FP220A/320A

Supplier Level

Code no. 311 with control operation

Code no. 3112 with control panel operation

Parameter Designation Unit max min Preset Ind.

263 ihP 0 = Signal “high lift for walking foot” (M6), when key is 1 0 0 A/A/A/A

closed.

1 = Signal “high lift for walking foot” (M6), when key is

open.

(Function only if parameter 137 = 1)

264 iS1 0 = Signal “manual stacker” (M7), when key is closed. 1 0 0 A/A/A/A

1 = Signal “manual stacker” (M7), when key is open.

(Function in all modes except mode 16)

265 ktS ON period of manual stacker (M7) ms 2550 **) 0 500 A/A/A/A

266 inr 0 = Limited speed n12 pedal controlled, when key is 1 0 0 A/A/A/A

closed.

1 = Limited speed n12 pedal controlled, when key is

open.

(Function if parameters 240...249 = 11)

269 PSv Positioning shift degrees 100 0 15 *) A/A/A/A

270 PGm Connection of a sensor e. g. light barrier sensor to 5 0 0 *) A/A/A/A

light barrier socket B18/7. Selection of the desired

function!

0 = The positions are generated by means of the

transmitter incorporated in the motor and can be set

by means of parameter 171.

1 = Setting the sensor to position 2.

Set position 1 using parameter 271, starting from

leading edge position 2.

2 = Setting the sensor to position 2.

Set position 1 using parameter 271, starting from

trailing edge position 2.

3 = Setting the sensor to position 1.

Set position 2 using parameter 271, starting from

leading edge position 1.

4 = Setting the sensor to position 1.

Set position 2 using parameter 271, starting from

trailing edge position 1.

5 = No position sensor available. The drive stops

unpositioned. The thread trimmer function is

suppressed with this setting.

*) Depending on the selected mode. See table at the beginning of the List of Parameters!

**) When programming the 3-digit or 4-digit control parameter values (without control panel), the 2-digit or 3-digit

value displayed must be multiplied by 10.

= 0V

OUT

ST2

POS1

ST2/21

POS2

ST2/20

POS1

ST2/21

ST2/20

POS2

ST2/21

POS1

ST2/20

POS1

ST2/20

POS

B18/7

ST2/21

POS2

SEN

= high

0256/ SEN- 1

Pa 271

360°

270 = 1270 = 3270 = 4 270 = 2

+5V

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 87 88

Comentarios a estos manuales

Sin comentarios

Duerkopp Adler HP Series Additional guide Manual de usuario Pagina 77

Comentarios a estos manuales

Relacionado con productos y manuales para Máquinas De Coser Duerkopp Adler HP Series Additional guide