Duerkopp Adler HP Series Additional guide Manual de usuario descargar pdf (Pagina 74)

EFKA AB220A/320A FP220A/320A

Supplier Level

Code no. 311 with control operation

Code no. 3112 with control panel operation

Parameter Designation Unit max min Preset Ind.

234 PdO New start after machine run blockage 1 0 1 A/A/A/A

0 = New start after disabling machine run

blockage without influence by the pedal

(e. g. with automats)

1 = New start after disabling machine run

blockage only if pedal in pos. 0

235 bkS Braking curve in the overlock mode On/Off 1 0 0 A/A/A/A

0 = Braking curve Off

1 = Braking curve On for precise stop upon chain

suction at the seam end

236 FLP 0 = Sewing foot lift possible in all positions 2 0 0 A/A/A/A

1 = Sewing foot lift possible in position 2

2 = Sewing foot lift at the seam end stored with pedal

backward. Storing undone with pedal slightly forward.

237 tkS Switch-off delay for chain suction at the ms 2550 **) 0 0 A/A/A/A

seam end, if parameter 022 = 2.

238 EnP Software debouncing for all inputs: 1 0 1 A/A/A/A

0 = No debouncing

1 = With debouncing

239 FEL Selection of the input function on socket B18/5 66 0 0 F/F/F/E

0 = Light barrier function, if 009 = 1

All other functions as with parameter 240.

240 in1 Selection of the input functions on socket ST2/7 66 0 0 *) F/F/F/E

for input 1

0 = No function

1 = Needle up/down

2 = Needle up

3 = Single stitch (basting stitch)

4 = Full stitch

5 = Needle to position 2

6 = Machine run blockage effective with open

contact

7 = Machine run blockage effective with closed

contact

8 = Machine run blockage unpositioned effective

with open contact

9 = Machine run blockage unpositioned effective

with closed contact

10 = Automatic speed n12 without pedal

11 = Limited speed n12 pedal controlled

(see parameter 266)

12 = Sewing foot lifting with pedal in position 0

(neutral)

13 = High lift for walking foot with speed limitation n10

(operational mode not stored)

14 = High lift for walking foot (flip-flop 1) with speed

limitation n10

15 = Tape cutter / fast scissors, function only in

chainstitch and overlock mode

16 = Intermediate backtack / intermediate stitch

condensing

17 = Stitch regulator suppression / recall

18 = Unlocking the chain, can be activated by

keystroke, but will be executed only at the

seam end

19 = Reset bobbin thread monitor if parameter

030 = >0

20 = Handwheel running in the direction of rotation

according to the setting of parameter 161

*) Depending on the selected mode. See table at the beginning of the List of Parameters!

**) When programming the 3-digit or 4-digit control parameter values (without control panel), the 2-digit or 3-digit

value displayed must be multiplied by 10.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 87 88

Comentarios a estos manuales

Sin comentarios

Duerkopp Adler HP Series Additional guide Manual de usuario Pagina 74

Comentarios a estos manuales

Relacionado con productos y manuales para Máquinas De Coser Duerkopp Adler HP Series Additional guide