Duerkopp Adler HP Series Additional guide Manual de usuario descargar pdf (Pagina 71)

EFKA AB220A/320A FP220A/320A

Technician Level

Code no. 190 with control operation

Code no. 1907 with control panel operation

Parameter Designation Unit max min Preset Ind.

187 FFo Function of signal M10 after “power On” (flip-flop 2) 1 0 0 *) A/A/A/A

on socket ST2/29

0 = Signal M10 Off / speed limitation n11

according to setting of parameter 186

1 = Signal M10 On / speed limitation n11

according to setting of parameter 186

188 hP Minimum speed level for high lift for walking foot 21 1 A/A/A/A

Maximum speed level for high lift for walking foot 21 1 A/A/A/A

Assignment of maximum speed (parameter 111) and

minimum speed (parameter 117) to the 21 speed levels

depending on high lift.

Display example:

2740 05 11 19

05 = Display of the level up to which the maximum

speed is effective.

19 = Display of the level up to which the minimum

speed is effective.

11 = Display of the speed level depending on high

lift set on the potentiometer.

2740 = Corresponding speed

See instruction manual on how to change the

setting!

190 MEK Function “unlock the chain” in modes 5, 6, 7 and 16 4 0 1 *) A/A/A/A

(parameter 290)

0 = Unlocking the chain Off

1 = Unlocking the chain manually (with pedal in

pos. –2 without cutting at the seam end)

2 = Unlocking the chain automatically

- by means of light barrier or

- pedal in pos. –2 (parameter 019) without

cutting at the seam end

3 = Unlocking the chain automatically

- by means of light barrier or

- pedal in pos. –2 (parameter 019) with cutting

and run-out stitches (parameter 184) at the

seam end, then unlocking the chain (only if

parameter 290 = 7)

4 = Unlocking the chain only with pedal in pos. –2.

No unlocking the chain with seam end by

means of light barrier, cutting and run-out stitches.

191 MHE Seam end in the overlock mode by end count c2 or c4 1 0 0 A/A/A/A

0 = Seam end after count c4 – tape cutter

1 = Seam end after count c2 – chain suction

192 PLS Speed of the light barrier compensating stitches 1 0 0 *) A/A/A/A

0 = Speed n5 after light barrier sensing

1 = Speed pedal controlled

193 kSL Enable chain suction signal and thread tension release 1 0 0 A/A/A/A

0 = Thread tension release and chain suction after

the light barrier compensating stitches

1 = Chain suction from light barrier uncovered

onwards and thread tension release after the

light barrier compensating stitches

194 Stb Function “blow fabric onto stack” 1 0 0 *) A/A/A/A

(only if parameter 290 = 16)

0 = Blow fabric onto stack at the seam end

1 = Blow fabric onto stack from light barrier

uncovered onwards

*) Depending on the selected mode. See table at the beginning of the List of Parameters!

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 87 88

Comentarios a estos manuales

Sin comentarios

Duerkopp Adler HP Series Additional guide Manual de usuario Pagina 71

Comentarios a estos manuales

Relacionado con productos y manuales para Máquinas De Coser Duerkopp Adler HP Series Additional guide