
EFKA AB220A/320A FP220A/320A
13
EB.. Actuator
Pedal step è
èè
è -2-10½123456789101112
Input A L L HHHL L HHL L HHL L H
Input B LHHLLLHHHHL L L L HH
Input C HHHHLLLLLLLLHHHH
Input D HHHHHHHHL LLLLLLL
5.4 Connection of a Sewing Light with Transformer
§ Switch off the control and remove mains plug from outlet
§ Unscrew the control unit from the machine table
§ Loosen 4 screws (A)
§ Remove the mounting plate
§ Loosen 2 screws (B) each at the front and at the rear
§ Open the left part of the housing
§ Pull the sewing light cable through the cable bushing
§ Area (C): Connect strands with clamp on the printed circuit board
§ Insert earth lead into plug-in device on the housing part
§ Close and screw-connect the housing
§ Mount the control unit on the machine table
CAUTION!
When the sewing light is connected, it is always current-carrying (230V), even if
the control unit is switched off! Only one sewing light with transformer can be
connected to the control unit!
TTENTION!
Before opening the cover, turn power off!
A
B
C
-
>>
+
P
E
KL2399
0
I
Comentarios a estos manuales