Duerkopp Adler HP Series Additional guide Manual de usuario descargar pdf (Pagina 75)

EFKA AB220A/320A FP220A/320A

Supplier Level

Code no. 311 with control operation

Code no. 3112 with control panel operation

Parameter Designation Unit max min Preset Ind.

21 = Handwheel running in the opposite direction of

rotation according to the setting of parameter

161

22 = Speed limitation n11 (flip-flop 2). Output

ST2/29 is enabled according to setting of

parameter 186

23 = No function

24 = Needle to position 2 (see instruction manual)

25 = Speed limitation with ext. potentiometer

On/Off (see parameter 126)

26 = Manual stacker

27 = Unlocking the chain, function is performed

upon pressing the key

28 = External light barrier (according to setting of

parameter 131)

29 = “Hemmer foot” signal Off (see parameter 296),

function effective only in the seam

30 = High lift for walking foot, if sewing foot is On

31 = Function “speed limitation bit0” (speed n11)

32 = Function “speed limitation bit1” (speed n10)

(bit0 + bit1 = speed n9).

33 = Speed n9 pedal controlled

34 = Automatic speed n9 can be suspended by

pressing the pedal to pos. 0 (neutral)

35 = Automatic speed n9 can be interrupted by

pressing the pedal to pos. -2

36 = Automatic speed n9 without pedal

37 = Speed n12 pedal controlled (break contact)

38 = Automatic speed n12 without pedal

(break contact [N.C.])

39 = Switch to the next pattern in TEACH IN

40 = Switch back to the previous pattern in TEACH IN

41 = Tape cutting only at machine standstill

42 = Enable hot thread chain cutting or sewing foot

lifting. Function effective only in the chain stitch

mode.

43 = No function

44 = Function like pressing the pedal to pos. -2

45..47 = No function

48 = Signal A1 is issued

49 = Signal A1 switchable as flip-flop

50 = No function

51 = Signal A2 is issued

52 = Signal A2 switchable as flip-flop

53 = No function

54 = Function like pressing the pedal to step 12.

If start backtack or softstart is enabled, it

will be performed.

55 = Reversal of the direction of rotation

56 = No function

57 = Input for Juki bobbin thread monitor

58..65 = No function

66 = Thread trimming is suppressed

241 in2 Selection of input function on socket ST2/11 66 0 0 *) F/F/F/E

for input 2

0 = No function

All other functions of the keys as with parameter 240

242 in3 Selection of input function on socket ST2/6 66 0 0 *) F/F/F/E

for input 3

0 = No function

All other functions of the keys as with parameter 240

*) Depending on the selected mode. See table at the beginning of the List of Parameters!

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 87 88

Comentarios a estos manuales

Sin comentarios

Duerkopp Adler HP Series Additional guide Manual de usuario Pagina 75

Comentarios a estos manuales

Relacionado con productos y manuales para Máquinas De Coser Duerkopp Adler HP Series Additional guide