Duerkopp Adler HP Series Additional guide Manual de instrucciones descargar pdf (Pagina 75)

EFKA AB220A511175

Supplier Level

Code no. 311 with control operation

Code no. 3112 with control panel operation

Note

When selecting the trimming mode by means of parameter 290, the connected V810 or V820 control panel is

automatically sensed and the corresponding slide-in strip number is selected by means of parameter 291 and 292,

respectively. Should a different strip be inserted, its number can be set by means of parameter 291 and 292, respectively,

after having selected the trimming mode.

Parameter Designation Unit max min Preset Ind.

291 810 Select slide-in strip number for the V810 control 12 1 1 *) A

panel (illustrations of slide-in strips see the

following chapter 9)

292 820 Select slide-in strip number for the V820 control 10 1 1 *) A

panel (illustrations of slide-in strips see the

following chapter 9)

293 tF1 Selection of the input function by means of the 19 0 17 *) A

(A) key “F1” on the V810/V820 control panel

0 =No function

1 =Needle up/down

2 =Needle up

3 =Single stitch (basting stitch)

4 =Full stitch

5 =Needle to position 2

6...12 =No function

13 =High lift for walking foot with speed limitation

n10 (operational mode not stored)

14 =High lift for walking foot with speed limitation

n10 (operational mode stored)

15 =Tape cutter / fast scissors

(in chainstitch and overlock mode)

16 =Intermediate backtack/intermediate stitch

condensing

17 =Stitch regulator suppression / recall

18 =No function

19 =Reset bobbin thread monitor if parameter

030 = >0

294 tF2 Selection of the input function by means of the 19 0 1 *) C

(B) key “F2” on the V810/V820 control panel

Functions of the key as with parameter 293

295 nAM Switch proximity switches for inputs in2, in7, in8, in9 1 0 0 A

296 M08 Functions of signal M8 5 0 0 *) A

0 = Signal M8 Off

1 = Signal hemmer foot On at the start of the seam

with pedal in pos. -1 or –2 and in the seam with

machine running

2 = Signal hemmer foot On at the start of the seam

with pedal in pos. -1 or –2 and remains active in

the seam

3 = Signal M8 as center cutter

4 = Signal M8 with needle up / down

5 = Signal M8 alternating with M3 with “fast scissors”

on overlock machines in mode 16,

if parameter 232=1 has been selected

*) Depending on the selected mode. See table at the beginning of the List of Parameters!

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 83 84

Comentarios a estos manuales

Sin comentarios

Duerkopp Adler HP Series Additional guide Manual de instrucciones Pagina 75

Comentarios a estos manuales

Relacionado con productos y manuales para Máquinas De Coser Duerkopp Adler HP Series Additional guide