Duerkopp Adler HP Series Additional guide Manual de instrucciones descargar pdf (Pagina 70)

EFKA AB220A5111

Supplier Level

Code no. 311 with control operation

Code no. 3112 with control panel operation

Parameter Designation Unit max min Preset Ind.

250 iFA Thread trimmer activation angle degrees 259 0 180 *) A

251 FSA Switch-off delay of thread tension release ms 990 0 50 *) A

252 FSE Switch-on delay angle of thread tension release degrees 259 0 0 *) A

253 tFA Stop time for thread trimmer ms 500 **) 0 70 *) A

254 EF- Upper limit (pa. 204) duty ratio for sewing % 100 1 100 *) A

foot lift 1...100

255 EV- Upper limit (pa. 213) duty ratio for backtacking % 100 1 100 *) A

or thread trimmer backward 1...100

256 kt6 Delay time of output VR (chain suction), ms 2550 **) 0 250 A

(function only if parameter 290 = 15)

257 c7 Start counting until tape cutter M4 On stitches 254 0 5 A

(function only if parameter 290 = 15)

258 c8 End counting until tape cutter M4 On stitches 254 0 15 A

(function only if parameter 290 = 15)

260 ihr Handwheel increments carried out when the incr. 500 0 10 *) A

key is pressed once (in1...i10)

261 nhr Handwheel speed RPM 150 **) 30 50 A

262 dhr Delay time until the key is pressed down ms 2550 **) 0 200 *) A

causing the handwheel to rotate continuously

(in1...i10).

Pressing the key briefly < preset value of

parameter 262: increments set by means of

parameter 260 are carried out.

Keeping the key pressed down > preset value

of parameter 262: handwheel rotates

continuously.

263 ihP 0 =Signal “high lift for walking foot” (M6), when key is 1 0 0 A

closed.

1 =Signal “high lift for walking foot” (M6), when key is

open.

(Function only if parameter 137 = 1)

264 iS1 0 =Signal “manual stacker” (M7), when key is closed. 1 0 0 A

1 =Signal “manual stacker” (M7), when key is open.

(Function in all modes except mode 16)

265 ktS ON period of manual stacker (M7) ms 2550 **) 0 500 A

266 inr 0 =Limited speed n12 pedal controlled, when key is 1 0 0 A

closed.

1 =Limited speed n12 pedal controlled, when key is

open.

(Function if parameters 240...249 = 11)

269 PSv Positioning shift degrees 100 0 15 *) A

*) Depending on the selected mode. See table at the beginning of the List of Parameters!

**) When programming the 3-digit or 4-digit control parameter values (without control panel), the 2-digit or 3-digit

value displayed must be multiplied by 10.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 83 84

Comentarios a estos manuales

Sin comentarios

Duerkopp Adler HP Series Additional guide Manual de instrucciones Pagina 70

Comentarios a estos manuales

Relacionado con productos y manuales para Máquinas De Coser Duerkopp Adler HP Series Additional guide