Duerkopp Adler HP Series Additional guide Manual de instrucciones Pagina 13

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 84
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 12
EFKA AB220A511113
EB.. Actuator
Pedal step èè -2 -1 0 ½ 1 2 3 4 5 6 7 8 9 10 11 12
Input A L L H H H L L H H L L H H L L H
Input B L H H L L L H H H H L L L L H H
Input C H H H H L L L L L L L L H H H H
Input D H H H H H H H H L L L L L L L L
4.4 Connection of a Sewing Light with Transformer
§ Switch off the control and remove mains plug from outlet
§ Unscrew the control unit from the machine table
§ Loosen 4 screws (A)
§ Remove the mounting plate
§ Loosen 2 screws (B) each at the front and at the rear
§ Open the left part of the housing
§ Pull the sewing light cable through the cable bushing
§ Area (C): Connect strands with clamp on the printed circuit board
§ Insert earth lead into plug-in device on the housing part
§ Close and screw-connect the housing
§ Mount the control unit on the machine table
CAUTION!
When the sewing light is connected, it is always current-carrying (230V), even if
the control unit is switched off! Only one sewing light with transformer can be
connected to the control unit!
A
B
C
-
>>
+
P
E
KL2399
0
I
ATTENTION!
Before opening the cover, turn power off!
Vista de pagina 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 83 84

Comentarios a estos manuales

Sin comentarios