Duerkopp Adler HP Series Additional guide Manual de instrucciones Pagina 61
- Pagina / 84
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
EFKA AB220A511161
7.3 Technician Level
Code no. 190 with control operation
Code no. 1907 with control panel operation
Parameter Designation Unit max min Preset Ind.
100 SSc Number of softstart stitches stitches 254 0 2 *) A
110 n1 Positioning speed RPM 390 **) 70 200 *) A
111 n2- Upper limit setting range of the maximum speed RPM 9900 **) n2_ 4000 *) A
112 n3 Start backtacking speed RPM 9900 **) 200 1200 *) A
113 n4 End backtacking speed RPM 9900 **) 200 1200 *) A
114 n5 Speed after light barrier sensing RPM 9900 **) 200 1200 A
115 n6 Softstart speed RPM 1500 **) 70 500 *) A
116 n7 Trimming speed RPM 500 **) 70 200 *) A
117 n10 High lift walking speed RPM 9900 **) 400 1000 *) A
118 n12 Automatic speed for stitch counting RPM 9900 **) 400 3500 *) A
119 nSt Speed stage graduation 3 1 2 *) A
1 = linear
2 = slightly progressive
3 = highly progressive
121 n2_ Lower limit setting range of the maximum speed RPM n2- **) 400 400 A
122 n9 Limited speed n9 RPM 9900 **) 400 2000 *) A
123 n11 Limited speed n11 RPM 9900 **) 400 2500 *) A
124 toP Speed limitation by means of ext. potentiometer RPM 9900 **) Pa.125 4000 A
(maximum value)
125 bot Speed limitation by means of ext. potentiometer RPM Pa.124 **) 400 400 A
(minimum value)
126 Pot Function “speed limitation by means of external 4 0 0 A
potentiometer”
0 = Function “external potentiometer” Off
1 = External potentiometer always active
2 = External potentiometer active only if one of
inputs in1...i10 has been selected and enabled
3 = Speed depending on high lift by means of
potentiometer e. g. on JUKI (LU2210/ 2260)
4 = Speed depending on high lift by means of
potentiometer e. g. on Dürkopp Adler (767)
127 AkS Audible signal of machine run blockage and bobbin 1 0 0 A
thread monitor On/Off
128 Asd Start delay, when command “start” is given by ms 2000 **) 0 0 A
covering the light barrier
(see parameter 129)
129 ALS Machine start by covering the light barrier 3 0 0 A
(only in conjunction with parameter 132 = 1)
0 = Function Off
1 = Light barrier covered è pedal forward (>1)
è machine run pedal controlled
2 = Pedal forward (>1) è light barrier covered
è machine run pedal controlled
3 = Light barrier covered è machine run at
automatic speed n12 (without pedal)
Caution! If 129 = 3, the machine starts immediately
after covering the light barrier without influence by
the pedal! It can be stopped only by uncovering the
light barrier or by machine run blockage! If machine
run blockage is disabled, the machine starts
immediately even if the light barrier is still covered!
130 LSF Light barrier filter for knitted fabrics 1 0 0 *) A
131 LSd 0 = Light barrier sensing “covered” 1 0 1 *) A
1 = Light barrier sensing “uncovered”
*) Depending on the selected mode. See table at the beginning of the List of Parameters!
**) When programming the 3-digit or 4-digit control parameter values (without control panel), the 2-digit or 3-digit
value displayed must be multiplied by 10.
- CONTROL AB220A5111 1
- LIST OF PARAMETERS 1
- EFKA AB220A51113 3
- CONTENTS Page 3
- 1 Table of Adapter Cords 5
- 2 Putting into Service 6
- Routine (SIR) 7
- EFKA AB220A51119 9
- EFKA AB220A5111 10
- 4.3 Connection Diagram 10
- EFKA AB220A511111 11
- ATTENTION! 12
- EFKA AB220A511113 13
- EFKA AB220A511115 15
- 5.1 Adapter Cords 15
- Nr. 1112822 16
- EFKA AB220A511117 17
- EFKA AB220A511119 19
- Nr. 1113200 19
- EFKA AB220A511121 21
- EFKA AB220A511123 23
- Nr.1113267 23
- EFKA AB220A511125 25
- Nr. 1112823 25
- EFKA AB220A511127 27
- Nr. 1113178 28
- EFKA AB220A511129 29
- 6 Timing Diagrams 30
- EFKA AB220A511131 31
- EFKA AB220A511133 33
- EFKA AB220A511135 35
- EFKA AB220A511137 37
- EFKA AB220A511139 39
- EFKA AB220A511141 41
- EFKA AB220A511143 43
- EFKA AB220A511145 45
- EFKA AB220A511147 47
- EFKA AB220A511149 49
- EFKA AB220A511151 51
- EFKA AB220A511153 53
- EFKA AB220A511155 55
- 7 List of Parameters 57
- Supplier Level 58
- EFKA AB220A511159 59
- 7.2 Operator Level 59
- Operator Level 60
- EFKA AB220A511161 61
- 7.3 Technician Level 61
- Technician Level 62
- EFKA AB220A511163 63
- EFKA AB220A511165 65
- EFKA AB220A511167 67
- 7.4 Supplier Level 67
- EFKA AB220A511169 69
- EFKA AB220A511171 71
- EFKA AB220A511173 73
- EFKA AB220A511175 75
- EFKA AB220A511177 77
- EFKA AB220A511179 79
- 8 Error Displays 80
- EFKA AB220A511183 83
- OF AMERICA INC 84
Relacionado con productos y manuales para Máquinas De Coser Duerkopp Adler HP Series Additional guide
(6 paginas)
Máquinas De Coser Duerkopp Adler 806 Manual de servicio
(114 paginas)
(114 paginas)
(88 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.021 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales