Duerkopp Adler HP Series Additional guide Manual de instrucciones Pagina 65
- Pagina / 84
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
EFKA AB220A511165
Technician Level
Code no. 190 with control operation
Code no. 1907 with control panel operation
Parameter Designation Unit max min Preset Ind.
188 hP Minimum speed level for high lift for walking foot 21 1 A
Maximum speed level for high lift for walking foot 21 1 A
Assignment of maximum speed (parameter 111) and
minimum speed (parameter 117) to the 21 speed levels
depending on high lift.
Display example:
2740 05 11 19
05 = Display of the level up to which the maximum
speed is effective.
19 = Display of the level up to which the minimum
speed is effective.
11 = Display of the speed level depending on high
lift set on the potentiometer.
2740= Corresponding speed
See instruction manual on how to change the
setting!
190 MEK Function “unlock the chain” in modes 5, 6, 7 and 16 4 0 1 *) A
(parameter 290)
0 = Unlocking the chain Off
1 = Unlocking the chain manually (with pedal in
pos. –2 without cutting at the seam end)
2 = Unlocking the chain automatically
- by means of light barrier or
- pedal in pos. –2 (parameter 019) without
cutting at the seam end
3 = Unlocking the chain automatically
- by means of light barrier or
- pedal in pos. –2 (parameter 019) with cutting
and run-out stitches (parameter 184) at the
seam end, then unlocking the chain (only if
parameter 290 = 7 and 16)
4 = Unlocking the chain only with pedal in pos. –2.
No unlocking the chain with seam end by
means of light barrier, cutting and run-out stitches.
191 MHE Seam end in the overlock mode by end count c2 or c4 1 0 0 A
0 = Seam end after count c4 – tape cutter
1 = Seam end after count c2 – chain suction
192 PLS Speed of the light barrier compensating stitches 1 0 0 *) A
0 = Speed n5 after light barrier sensing
1 = Speed pedal controlled
193 kSL Enable chain suction signal and thread tension release 1 0 0 A
0 = Thread tension release and chain suction after
the light barrier compensating stitches
1 = Chain suction from light barrier uncovered
onwards and thread tension release after the
light barrier compensating stitches
194 Stb Function “blow fabric onto stack” 1 0 0 *) A
(only if parameter 290 = 16)
0 = Blow fabric onto stack at the seam end
1 = Blow fabric onto stack from light barrier
uncovered onwards
195 LSc Stitches for light barrier monitoring stitches 2550 **) 0 0 A
(light barrier monitoring is off, when set to “0”).
*) Depending on the selected mode. See table at the beginning of the List of Parameters!
**) When programming the 3-digit or 4-digit control parameter values (without control panel), the 2-digit or 3-digit
value displayed must be multiplied by 10.
- CONTROL AB220A5111 1
- LIST OF PARAMETERS 1
- EFKA AB220A51113 3
- CONTENTS Page 3
- 1 Table of Adapter Cords 5
- 2 Putting into Service 6
- Routine (SIR) 7
- EFKA AB220A51119 9
- EFKA AB220A5111 10
- 4.3 Connection Diagram 10
- EFKA AB220A511111 11
- ATTENTION! 12
- EFKA AB220A511113 13
- EFKA AB220A511115 15
- 5.1 Adapter Cords 15
- Nr. 1112822 16
- EFKA AB220A511117 17
- EFKA AB220A511119 19
- Nr. 1113200 19
- EFKA AB220A511121 21
- EFKA AB220A511123 23
- Nr.1113267 23
- EFKA AB220A511125 25
- Nr. 1112823 25
- EFKA AB220A511127 27
- Nr. 1113178 28
- EFKA AB220A511129 29
- 6 Timing Diagrams 30
- EFKA AB220A511131 31
- EFKA AB220A511133 33
- EFKA AB220A511135 35
- EFKA AB220A511137 37
- EFKA AB220A511139 39
- EFKA AB220A511141 41
- EFKA AB220A511143 43
- EFKA AB220A511145 45
- EFKA AB220A511147 47
- EFKA AB220A511149 49
- EFKA AB220A511151 51
- EFKA AB220A511153 53
- EFKA AB220A511155 55
- 7 List of Parameters 57
- Supplier Level 58
- EFKA AB220A511159 59
- 7.2 Operator Level 59
- Operator Level 60
- EFKA AB220A511161 61
- 7.3 Technician Level 61
- Technician Level 62
- EFKA AB220A511163 63
- EFKA AB220A511165 65
- EFKA AB220A511167 67
- 7.4 Supplier Level 67
- EFKA AB220A511169 69
- EFKA AB220A511171 71
- EFKA AB220A511173 73
- EFKA AB220A511175 75
- EFKA AB220A511177 77
- EFKA AB220A511179 79
- 8 Error Displays 80
- EFKA AB220A511183 83
- OF AMERICA INC 84
Relacionado con productos y manuales para Máquinas De Coser Duerkopp Adler HP Series Additional guide
(6 paginas)
Máquinas De Coser Duerkopp Adler 806 Manual de servicio
(114 paginas)
(114 paginas)
(88 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.051 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales