Duerkopp Adler HP Series Additional guide Manual de instrucciones descargar pdf (Pagina 60)

EFKA AB220A5111

Operator Level

Parameter Designation Unit max min Preset Ind.

019 -Pd 0 = Pedal in pos. –1 disabled in the seam. With pedal in 4 0 3 *) A

pos. –2 in the seam, only sewing foot lifting is

possible. (Function only if parameter 009 = 1)

1 = Pedal in pos. –1, sewing foot lifting disabled in the

seam.

2 = Pedal in pos. –2, thread trimming disabled.

(Function only if parameter 009 = 1)

3 = Pedal in pos. –1 and –2 enabled in the seam.

4 = Pedal in pos. –1 and –2 blocked in the seam.

(Function only if parameter 009 = 1)

020 kLM Clamp at the seam end On/Off 1 0 0 A

021 ckL Run-out stitches clamp at the start of the seam stitches 254 0 2 *) A

022 SPo 0 = Chain suction until the end of count c2 2 0 0 A

1 = Chain suction at the seam end until pedal in

pos. 0 (neutral)

2 = Chain suction until the drive is at standstill

and the switch-off delay (parameter 237) has

elapsed

023 AFL Automatic sewing foot lifting with pedal forward 1 0 1 E

at the seam end, if light barrier or stitch counting is On

0 = Automatic sewing foot Off

1 = Automatic sewing foot On

025 tFS Start counting (pa. 157) for thread tension release 1 0 1 A

at the start of the seam

0 = Start counting at the start of the seam

1 = Start counting when the light barrier is covered

030 rFw 0 = Bobbin thread monitor Off 6 0 0 A

1 = Bobbin thread monitor with stop

2 = Bobbin thread monitor without stop

3 = Bobbin thread monitor with stop and start

blockage after thread trimming

4 = As 1, but display of remaining stitches

5 = As 2, but display of remaining stitches

6 = As 3, but display of remaining stitches

031 cFw Number of stitches for bobbin thread monitor stitches 25500 ***) 0 0 A

*) Depending on the selected mode. See table at the beginning of the List of Parameters!

***) When programming the 5-digit (max) parameter values on the control or control panel, the 3-digit value displayed

must be multiplied by 100.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 83 84

Sin comentarios

Duerkopp Adler HP Series Additional guide Manual de instrucciones Pagina 60