Duerkopp Adler FLP Series Additional guide Manual de servicio Pagina 64

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 74
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 63
Set-up
Operating manual 281 Version 06.0 - 05/201362
7.12 Attaching the control panel
Figure 40: Attaching the control panel
1. Loosen the fastening screws (4).
2. Remove the control panel bracket (3).
3. Screw the control panel (2) onto the control panel bracket (3).
4. Screw the control panel bracket (3) firmly onto the machine
arm again using the fastening screws (4).
5. Screw the connecting cable for the control panel firmly onto
the machine arm using the cable holder (1).
6. Loosen all three handwheel screws (5).
7. Loosen all four handwheel cover screws (6).
8. Remove the handwheel cover (7).
9. Install the connecting cable for the control panel tidily
underneath the handwheel cover and guide it downwards
through the table plate cut-out.
10. Fit the handwheel cover (7).
11. Tighten all three handwheel screws (5).
12. Tighten all four handwheel cover screws (6).
(1) - Cable holder
(2) - Control panel
(3) - Control panel bracket
(4) - Fastening screws
(5) - Handwheel screws
(6) - Handwheel cover screws
(7) - Handwheel cover
Vista de pagina 63
1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 73 74

Comentarios a estos manuales

Sin comentarios